What are the common problems of mechanism charcoal machine,how to solve the common problems of charc

The mechanism charcoal machine is an environmentally friendly equipment for the production of mechanism charcoal from biomass waste. It has high production efficiency and good quality. The mechanism charcoal produced can be widely used in the market and has been favored by the majority of users. Users have been operating mechanism charcoal in recent times There will also be some failures during the machine, so what are the common problems of the charcoal machine? How to solve the common problems of the charcoal machine?

charcoal machine

1. The power indicator of the console is off

Reasons: ① The power of the charcoal machine is not connected; ② The fuse is blown; ③ The indicator light is broken.

Corrective measures: ① Connect the power cord of the mechanism charcoal machine; ② replace the fuse; ③ replace the indicator cannon.

2. The mechanism charcoal machine motor does not start

Reasons: ① The control button of the charcoal machine is damaged; ② One phase is missing; ③ The voltage and frequency do not match.

Corrective measures: ① replace the control button of the charcoal machine; ② connect the power cord; ③ check the voltage and frequency.

3. The heating temperature rises slowly to less than 350 degrees

Reasons: ① The power supply voltage of the mechanism charcoal machine is low; ② The resistance heating coil of the mechanism charcoal machine is damaged; ③ The model of the mechanism charcoal machine is incorrect when replacing the heating coil wire.

Corrective measures: ① Check the voltage of the mechanism charcoal machine; ② replace the resistance heating ring of the mechanism charcoal machine; ③ replace the wires of the mechanism charcoal machine as required.

4. Motor heating

Reasons: ① The mechanism charcoal machine is overloaded; ② The mechanism charcoal machine runs in two phases; ③ The mechanism charcoal machine bearing is damaged; ④ The mechanism charcoal machine air duct is blocked; ⑤ The mechanism charcoal machine has a high ambient temperature; ⑥ The mechanism charcoal machine voltage is unstable; ⑦ Mechanism charcoal machine rotor winding or indirect short circuit.

Corrective measures: ①Check the supply of mechanism charcoal machine materials; ②Check mechanism charcoal machine wires, switches, contacts; ③Replace mechanism charcoal machine bearings and install lubricating oil; ④Clean the mechanism charcoal machine debris and ventilate channels; ⑤Take Cooling measures; ⑥ adjust the charcoal machine voltage; ⑦ check and exclude.

5. The machine is not good

Reasons: ① The raw material humidity of the charcoal machine is too high; ② The heating temperature of the charcoal machine is low; ③ The charcoal machine contains materials in the spiral groove; ④ The groove on the heating cylinder of the charcoal machine is misaligned with the groove of the heating cylinder; ; ⑥ The inner sleeve of the charcoal machine bracket is worn; ⑦ The inner sleeve of the charcoal machine heating cylinder is worn; ⑧ The mechanism of the charcoal machine screw propeller is worn.

Corrective measures: ① heat the raw materials as required; ② increase the heating temperature; ③ remove the impurities in the spiral groove of the charcoal machine; ④ reinstall the inner sleeve of the heating cylinder; ⑤ check the voltage; ⑥ replace the inner jacket; ⑦ replace the inner sleeve of the heating cylinder; ⑧ Repair or replace the screw propeller.

The above are the common problems and solutions in the process of producing mechanism charcoal by mechanism charcoal machine. Mechanism charcoal machine manufacturers recommend that the majority of users should maintain and maintain them when operating the equipment to avoid its failure. When the equipment fails It needs to be resolved in time, so as to ensure the smooth production of the mechanism charcoal machine.